Raptor Glider First Flight

...good and bad

This morning I plucked up the courage to get the Raptor Glider out for its first flight at the paddocks. The morning was eminently suitable if not spectacular; cool and overcast with a gentle northerly blowing across the field.

The Raptor was flying with a 2200 25C 3S battery and 11x6 carbon props, powered by a spare Phoenix motor I had on the spares shelf, a setup-up which should provide sufficient urge to motor the Raptor along. Not that one needs an over-powerful setup for this type of glider; with broad two-metre long wings anything exceeding a pedestrian pace will have the lightweight Raptor heading straight up with the amount of lift it generates.

The Raptor, while significantly different in construction to the Phoenix 2000, is not dissimilar in overall proportion and design, so it was fair to expect similar performance. The main difference was the V-tail which, although having flight characteristics no different to a conventional layout, is a little concerning nonetheless.

Although the CoG was spot-on, I moved the battery to the front of the tray just to be sure, based on my experiences with the big Phoenix. So, having checked the control surfaces and reassured myself once more that the V-tail controls were really moving the right way, I powered up the motor ready to go.

The Raptor was instantly tugging at my hand, straining to be let free, so with a touch more power and a good throw, the big glider slid into the air. My immediate reaction was how gently it flew and, after a few seconds, that one needed to be careful on the power as it was nosing straight up, just like the Phoenix 2000. 

Dropping the power and levelling it off had the Raptor cruising slowly over the paddocks, my unease over the V-tail having dissipated with it behaving quite normally in all respects, except that I needed to adjust again to the slow roll rate of such big wings.

Things were going along peacefully until an ominous rattle was heard from the prop, so I cut power and glided down the raptor. Although I didn't manage to get much flying in, this brief opportunity to glide it showed just how well it flies, appearing to have an excellent glide angle and very stable manners.

A quick check under the hood once the Raptor was down revealed, rather startlingly, that the motor had come loose despite the mounting bolts still being well secure. It appears that the motor came loose from the bell mounting, perhaps the fault of a loose grub screw, despite it being brand new...